October 2026
How Many Pairs of Overalls Should Each Worker Get in a Laundry Rotation?
Too few sets and someone’s in yesterday’s kit. Too many and you’re paying to store garments nobody’s wearing.

You’ve just signed up for a workwear laundry contract, or you’re costing one out, and the uniform supplier asks how many sets per person you want ordering. Get this number wrong and you’ll find out the hard way — either staff are wearing stained overalls because the clean ones haven’t come back yet, or you’ve got a cupboard full of garments that never leave the shelf. The answer most sites land on is five sets per worker, but the right number depends on your collection frequency and how dirty the job actually is.
The starting point: three in play, two in the wash
A worker needs one set on their back. They need a spare for the day the first set gets soaked, torn, or just needs changing mid-shift. That’s two sets in active use. The rest sit in the laundry cycle — collected, washed, dried, pressed, and delivered back.
With a weekly collection, that cycle typically runs five to seven days door to door. To keep two sets always available to the worker while three or four are somewhere in transit or on the laundry floor, most operators settle on five sets per person. That gives enough buffer for one set to be out for repair or replacement without anyone going short.
Move to a twice-weekly collection and you can usually trim that to three to four sets, because garments spend less time away from site. Fewer sets in circulation means less capital tied up in stock and a smaller locker footprint — worth factoring in if storage space is tight.
Adjust for how dirty and how often the job changes kit
The five-set rule assumes one change of clothing a day. Some jobs need more:
Food production and abattoir work — staff often change at breaks and after any contamination event, not just at shift end. Budget six to seven sets per person if garments are changed twice daily, or run a top-up stock of extra tunics that aren’t tied to a named individual.
Heavy engineering, oil and grease trades — garments here don’t fail from dirt, they fail from fabric damage. You may need the same five-set rotation but a shorter lifespan on each set, meaning more frequent replacement stock rather than more sets in circulation at any one time.
Office-adjacent roles with light soiling — site managers, warehouse supervisors — can often run on three sets even with weekly collection, because the garments aren’t heavily soiled and a slightly tighter margin is tolerable.
If you’re unsure which category your team falls into, our workwear laundry service includes an assessment of soiling levels and change frequency before we recommend a stock figure, rather than defaulting everyone to the same number.
Worked example: a 40-person warehouse team
Take a 40-strong warehouse crew on weekly collection, one change of overalls per day, standard soiling. At five sets per person, that’s 200 sets in circulation at any given time — roughly 80 being worn, 40 as the spare-on-site buffer, and the remaining 80 moving through collection, wash, and delivery.
Drop to a twice-weekly collection at four sets per person and the same crew needs 160 sets, a meaningful saving on garment stock and storage without any gap in supply. This is the trade-off worth running past your laundry provider before you commit to a collection schedule: a tighter rotation costs more in collection frequency but less in standing stock, and the balance shifts depending on garment cost.
What happens if you under-order
Cutting it too fine shows up fast. A single delayed delivery — bad weather, a vehicle breakdown, a bank holiday shifting the schedule — leaves workers with nothing clean. On sites with hygiene or PPE requirements, that’s not just an inconvenience, it’s a compliance gap. Workers either wear soiled kit, which undermines the whole point of a managed uniform programme, or they’re sent home, which costs you a shift.
Building in one extra set beyond the bare minimum calculation is cheap insurance against exactly this. It’s a lot less expensive than lost labour hours or a client audit finding staff in kit that doesn’t meet standard.
What happens if you over-order
The opposite mistake is less dramatic but still costs money. Garments that sit unused don’t wash themselves into obsolescence, but they do tie up capital, and if sizes or roles change, you can end up with stock nobody fits into. Review your rotation numbers annually, especially after headcount changes or if you’ve switched collection frequency — a stock level set for weekly collection two years ago may be oversized if you’ve since moved to twice-weekly.
Getting the number right for your site
There’s no single correct figure that applies everywhere — it depends on collection frequency, soiling level, and how many changes a shift requires. What matters is working it through properly before you order stock, rather than guessing and adjusting after staff start complaining. The same logic that applies to industrial overalls applies just as well to chef whites and front-of-house uniforms covered in our restaurant linen service, where change frequency is often higher than people expect.
Not sure what your rotation should look like?
We’ll look at your headcount, soiling levels and collection options and work out a stock figure that won’t leave anyone short — or sat on garments you don’t need.
